03-15-2019 03:35 PM
I've created a custom option for a network range. The option number is 240, and it is a string value.
However, it's not appearing on the client side.
A network trace shows that this particular option is not in the offer packet (other options are visible).
How can I resolve this ?
Solved! Go to Solution.
03-18-2019 05:07 AM
There might be a clock issue or something during the trunking process. The clock might be working slow. Did you check the clock settings? In most the cases clocks, not working properly and this cause the delay between client and the user sites. The solution is to reset your clock and then again check the delay between sender and receiver. I hope that works.
Business Development Executive at Best Business writing service Dubai, UAE
03-18-2019 09:05 AM
Hello Sir. I believe that you may be responding to a different issue.
I do not see how clock adjustment would affect thee DHCP options being offered.
Just to note again that a single new custom DHCP option is not being presented; all others are.
03-18-2019 10:08 AM - edited 03-18-2019 10:08 AM
Please explain your configuration in detail so that we can understand better?
#1 - Did you navigate to DHCP-->Option Spaces tab, then created a new option space and specified 240 as string?
#2 - Did you navigate to DHCP-->Option Spaces tab and added 240 into the default IPv4 option space named DHCP?
#2 above just requires you to specify your option at a range or network and provide its value.
#1 above requires you to create an IPv4 option filter, then match client(s) based on ther VCI (option 60) and apply the filter on a range as a Logic filter.
When you perform the network trace, do you find the client asking for option 240 inside the Parameter Request List (PRL - Option 55) in a DHCPDISCOVER packet?
If your requirement is such that Infoblox provide all configured option(s) on a range, to client(s), regardless of whether they are requesting or not would require you to enable "Ignore optionlist requested by client and return all defined options". This can be configured on a range/network and certain other places and configuring it simply means that Infoblox writes an additional statement to dhcpd.conf to ignore the PRL from clients.
03-18-2019 10:52 AM
Thank you very much for the reply, it was very educational and helped to resolve the issue.
Once we checked the "Ignore optionlist requested by client and return all defined options" option on the advanced tab, we got expected results.
I was also facing this problem and searching for the solution thanks for the answers. The same problem i faced when i was doing essay writing in UAE but now problem solved
<Moderator> External link removed. Future postings will be monitored for abuse.