Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
named.conf configuration
Options
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
05-10-2016 07:58 AM
How much configuration can I do on named.conf? I would like to add query-source and listen-on address in named.conf so I can bind DNS to the loopback addresses.
Re: named.conf configuration
Options
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
05-10-2016 01:25 PM
The named.conf file cannot be modified directly, but it can be modified via the NIOS GUI.
You can set the listen-on via these steps:
- From the Data Management tab, select the DNS tab and click the Members tab -> member check box -> Edit icon.
- In the editor, click Toggle Advanced Mode.
- When the additional tabs appear, click the Advanced subtab of the General tab.
- Add the IP in "Listen on these additional IP addresses"
The "query-source" directive is covered in the same location by picking the correct interface from the "Send queries from" drop-down.
-
Duncan
Support Engineer
Infoblox
Duncan
Support Engineer
Infoblox