12-01-2016 08:54 PM
Baseed on this article, show process all is a valid command on NIOS
However, when tried the command in the CLI and in expert mode CLI, I got nowhere.
Your kind help is mostly appreciated.
Solved! Go to Solution.
05-08-2017 10:34 AM
The show process all command works only in the maintenance mode. Try the Following command:
Infoblox> set maintenancemode
Maintenance Mode> show process all
After collecting the data, please turn off the Maintenance Mode by using the following command:
Maintenance Mode> set maintenancemode off
NOTE: As suggested earlier, please use the command only with the help of Support