Infoblox Exchange Cybersecurity Roadshow 2020 – Join us!
North America | Europe | Middle East/Africa | Asia-Pacific

DNS DHCP IPAM

Reply
Accepted Solution

show process all command

Guru
Posts: 185
2709     0

Hi;

 

Baseed on this article, show process all is a valid command on NIOS

 

https://community.infoblox.com/t5/Security/Captive-Portal-authenticated-DHCP-performance-problem/td-...

 

However, when tried the command in the CLI and in expert mode CLI, I could not.

 

 

 

Kindly

Wasfi

Re: show process all command

[ Edited ]
TTiscareno Community Manager
Community Manager
Posts: 360
2710     0

To run the show process command, you will first need to enter maintenance mode:

 

set maintenancemode

 

You can enter maintenance mode using the above command, and you can exit it using the command set maintenancemode off, or by closing your (remote) console session. Entering into maintenance mode does not change the operation of your server, it only enables additional commands (such as this one) that you can run in the CLI. For expert mode, that is typically not used too often unless requested by Infoblox Support. The commands work entirely differently in that mode.

Showing results for 
Search instead for 
Do you mean 

Recommended for You