Getting Started

Reply
Highlighted
Accepted Solution

SNMP Recursion Thresholds Default Values can not be Changed to Default Values after Manually Change

[ Edited ]
yyye
Techie
Posts: 5
1010     0

I was trying to test SNMP Traps for Recursive clients Value  I  set the Trigger % Value to 2 and Reset Value to 1 % and were able to Test ,  however when trying to Inherit the Default Threshold Values again Trigger % 80 and Reset 30 % I received an Error Message “ An Invalid Value was Entered “

 

Looks Like SNMP Threshold Recursive clients Values  Stuck  at these Values Trigger 2 and 1 for Reset

 

I have Other Gride Memebers and Recursive clients Threshold Value Set to Default without any Issue ...any Advise Please What could be causing the issue .

 

Re: SNMP Recursion Thresholds Default Values can not be Changed to Default Values after Manually Cha

yyye
Techie
Posts: 5
1011     0

I managed to restore Default Values using CLI Command “ set thresholdtrap {type} trigger {value} reset {value}  “  Instead of using Grid GUI

Re: SNMP Recursion Thresholds Default Values can not be Changed to Default Values after Manually Cha

Guru
Posts: 70
1011     0
Showing results for 
Search instead for 
Do you mean 

Recommended for You