Introducing SOC Insights for BloxOne Threat Defense: Boost your SOC efficiency with AI-driven insights to eliminate manual work and accelerate investigation and response times. Read the blog announcement here.

NIOS DNS DHCP IPAM

Reply

ACI Rogue EP Control vs HA pair automatic failover

Authority
Posts: 14
1494     0

Hello Everybody, 

I post here because we have had an issue with an HA pair when we was upgrading the ACI.

To explain the architecture, the HA pair are in two different datacenter and have LAN1 and HA connected to one switch. LAN2 (configured like LAN1 redundancy) and MGMT are connected to a different switch.

 

So during the upgrade, the LAN1 and HA port of the active node was interrupted and the passive tried to become active but the VIP of HA did not appear until we are disabling the rogue ep control on ACI.

The rogue ep control was in default setting (rogue ep control intervalle : 60, rogue ep detection multiplication factor : 4, hold interval (1800).

Have you got the same problem or have you some advice ? 

Thanks,

Kind Regards,

Re: ACI Rogue EP Control vs HA pair automatic failover

Authority
Posts: 14
1495     0

Hi i have had this problem on ACI

https://community.infoblox.com/t5/Getting-Started/HA-pair-on-multipod-ACI-problem-multicast-keepaliv....

With another client we clould not reproduce this on the 8.5.2 nios firmware and ACI 4.2.6(d) release train. The problem i posted was at antother client that was still on 8.4.x nios version and ACI 3.2.6 release.

In both cases we don't use rouge endpoint control.

For other best practices on ACI this is also a good site :

https://unofficialaciguide.com/ for bestpractices in settings on Muti-pod fabric e.t.c

 

Showing results for 
Search instead for 
Did you mean: 

Recommended for You