Hello Team,
I am facing an issue in Infoblox NetMRI and would appreciate your guidance.
NetMRI Version: | 7.5.4.104695 |
|---|
Network Setup:
- Cisco Layer 3 switch is added and successfully discovered in NetMRI.
- NetMRI shows all switch information (interfaces, VLANs, MAC table, ARP, SNMP, etc.).
- A physical laptop is connected to switch port (GigabitEthernet0/30) via LAN cable.
- SNMP is enabled on the switch and working (NetMRI can poll successfully).
- However, the end device (laptop/host) is not visible in any of the following sections:
- Network Explorer → End Hosts
- Switch Port Management → Connected Hosts / MAC Table
- Device → Interfaces → Connected End Devices
Issue:
Even though the switch is fully discovered and visible in NetMRI, the laptop/end host connected to the switch port is not being detected or displayed
Request for Help:
Can you please guide me on:
- Do I need to enable any specific setting in NetMRI to collect MAC/ARP/End Host data?
- Is there any required Cisco configuration (e.g., IP Device Tracking, ARP timeout, port security, LLDP/CDP)?
- Do I need to enable Switch Port Management Polling separately for end host visibility?
