- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Suppress Dhcp threshold
[ Edited ]- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
01-09-2017 04:00 AM - edited 01-09-2017 04:02 AM
Hi
I know i've been here before, but im still badly in need of a solution, and is hoping for some advice:
We have several scope's with only one available IP address, when this single IP has been leased, the scope is full, and shows up red on the dashboard. Since we have several of theese full scopes, they hide the relevant warning about full scopes. I know we can prevent Email warnings scopewise by setting thresshold to 100% and 0% but how can we keep (certain) full scopes from showing on the dashboard ?
/JanV - Denmark
Re: Suppress Dhcp threshold
[ Edited ]- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
01-09-2017 07:54 AM - edited 01-09-2017 07:55 AM
Edit the IPv4 DHCP Range, toggle advanced mode and uncheck "Enable DHCP Thresholds" in the "IPv4 DHCP Thresholds" section of the menu.
That should do it.
Re: Suppress Dhcp threshold
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
01-10-2017 04:11 AM
Thanks a lot
Unfortunately the threshold disabled scope, still shows up in red on the dashboard.
I will try to send a request for change to Infoblox...
/Vejling - Denmark