- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
HA with two Trinzic appliances of different models
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-01-2021 02:53 AM
Hello,
Is it possible to configure two Trinzic appliances of different models in high availability (HA) mode ?
Primary - Trinzic 1410
Secondary - Trinzic 1405
Both in same NIOS version.
Re: HA with two Trinzic appliances of different models
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-16-2021 12:56 PM
AlaJeb,
Yes you can do it, but it is not best practice. A concern would be the database size between the two models.
Hope this helps.
Thomas
Re: HA with two Trinzic appliances of different models
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-02-2021 01:32 PM
Hi,
Since Infoblox uses VRRP protocol for HA communications, I guess you can do that, however I'd do it with two appliances of the same model.
Regards.
Re: HA with two Trinzic appliances of different models
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-20-2021 07:52 AM
that should be fine.
The key here is the 1405 needs to be licensed as a 1415 or 1425.
The DB sizes are the same (1410 vs 1415) or larger (if going to 1425)
That being said, the 1410 is end of life/end of support, so I'm hoping this is a migration and not a permanent state of affairs.