Offline
Member since 01-15-2014

Community record

8
Posts
0
Kudos
1
Solutions
It's great, you can only do it on Device Custom fields not Interfaces, I filed an RFE for it. Sif
Did you check the support portal? This thread is over a year old, so it's a good bet there's been updates to Security Alerts since the original post.
The following is a link to a KB article in the support site Upgrading Network Automation from Version 4.3.1 to Version 6.8.8 or 7.0.2 This has the information about upgrading to the latest version
I highly recommend upgrading to 6.9 minimum to get the XML ConfigBlockCheck. At that point, it will let you define block start and block end, then loop your logic for each block. -Jerry
You can now do it with version 7.x
With the 6.9.1 release. Please check out the release notes and updated admin guide on the support site for more info.
Working, Thanks John. Bernard.
Nick, If groups B, C, and D contain devices that are also in group A, and you g...

Kudos given to

Kudos given to