Reply

How do I break out from the set IPV6 after a set network command?

Guru
Posts: 58
2930     0

Hi;

 

Let's say I typed the command set network, then inadvertantly choose Y for setup IPV6. How do I break out from being stuck at that stage without having to reboot the appliance?

 

Kindly

Wasfi

Re: How do I break out from the set IPV6 after a set network command?

Authority
Posts: 14
2931     0
You don't, use a bogus ipv6 address and continue following the prompts.. at the end of the wizard, say no to the "are you sure" prompt and start over.
Showing results for 
Search instead for 
Did you mean: 

Recommended for You

NIOS 8.6.3 – What’s New in DDI