Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Net MRI cannot change parent Id of group child
Options
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-12-2021 12:33 PM
2277     0
howdy
i have been, without success, trying to change the parent ID of one of my groups so that it will be under the switching folder. i have tried deletion and re adding under the correct folder, and that works but then the group will not populate with my switch info. If i then install the group at the top level i can see my switches in the group. i am perplexed. please advise.
Labels:
Re: Net MRI cannot change parent Id of group child
Options
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-12-2021 02:38 PM
2278     0
Hi hbunger -
If your group is not populating after you have added it under as a child to the switching group, then I'd suspect that the switching group is filtering out the devices. Are your devices currently in the switching group? Can you share the rule logic of each? Maybe you need to tick the box for 'including low-level devices'?
Lon.
If your group is not populating after you have added it under as a child to the switching group, then I'd suspect that the switching group is filtering out the devices. Are your devices currently in the switching group? Can you share the rule logic of each? Maybe you need to tick the box for 'including low-level devices'?
Lon.